Hardware includes a SparkFun Bus Pirate with the 6.0RC1 firmware, a CA-42 cable off of eBay, and a 2.5-3.
#DOCKSTAR JTAG SOFTWARE#
Choose the right COM port and set the baud-rate to 115200 and turn off flow control. I installed OpenOCD from the software center and had some mild tweaks to the dockstar.cfg file to accommodate the different version. Now you are ready to connect to the dockstar with any tool of your choise. You connect the JTAG adapter to the JTAG port on the DockStar Thanks for the link. When everything is connected correctly it looks as follows. external 40 JTAG connector, comes with no documentation or support and has a reputation for flaky hardware), and the Seagate Dockstar (a great bargain. That is usually the case however the dockstar that inspired the JTAG recovery was indeed bricked. Mit der OpenOCD Version 0.7, die ber das Linux Mint Repository. Dockstar debian install, Porque guardiola dejo el barca vs madrid, Jabolcinja 2014. But one of the best parts is the floppy drive. Wollte das Ding fr das Flashen eines Flash-EPROMs in einer Seagate Dockstar verwenden. Today I decided to test it on my second dockstar and to take a look at the boot output. When the Mac is off the Dockstar still runs as a server. Techdata: Seagate DockStar Usage hideseceditbutton IMPORTANT : Edit this page only via the LEFT edit button below the dataentry box After editing, please enter. You need GND (black wired in the pictures), TxD (red) and RxD (white).
#DOCKSTAR JTAG SERIAL#
The pinout of the dockstar’s plug looks like this:ĭockstar plug J1 10 pin, Serial Link / JTAG (Pin counting pairwise) function In order to connect it to the dockstar I took a 3-pin cable off an old computer case and soldered connectors at the end of the wires and protected them with heat shrink tube against short. All handshaking and modem interface signalsĭata formats supported: 8-bit 1 Stop bitĥ12 byte receive buffer 512 byte transmit buffer
0 kommentar(er)
